HyperX Fury Red 4GB 1600MHz DDR3 CL10 DIMM Memory

Ebuyer.com £22.98 Go to Ebuyer.com First seen in Dec 2016

Description

Get in the game with HyperX FURY. Even newbies get up to speed fast, since Fury automatically recognises its host platform and automatically overclocks to up to 1866 MHz*, providing plenty of power for your next death match. Fury's asymmetric heatspreader design lets you stand out from the crowd. It's available in black, blue, red and for the first time in the HyperX line - white, with a black PCB. So your rig can reflect your style and you can show it off with pride. It's 100 per cent tested and LAN-ready plus it's backed by free technical support. *HyperX PnP memory will run in most DDR3 systems up to the speed allowed by the manufacturer's system BIOS. PnP cannot increase the system memory speed faster than is allowed by the manufacturer's BIOS. SPECIFICATIONS CL(IDD) 10 cycles Row Cycle Time (tRCmin) 48.125ns (min.) Refresh to Active/Refresh 260ns (min.) Command Time (tRFCmin) Row Active Time (tRASmin) 37.5ns (min.) Maximum Operating Power TBD W* UL Rating 94 V - 0 Operating Temperature 0oC to 85o C Storage Temperature -55oC to +100o C *Power will vary depending on the SDRAM used. FEATURES • JEDEC standard 1.5V (1.425V ~1.575V) Power Supply • VDDQ = 1.5V (1.425V ~ 1.575V) • 800MHz fCK for 1600Mb/sec/pin • 8 independent internal bank • Programmable CAS Latency: 11, 10, 9, 8, 7, 6 • Programmable Additive Latency: 0, CL - 2, or CL - 1 clock • 8-bit pre-fetch • Burst Length: 8 (Interleave without any limit, sequential with starting address “000” only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS] • Bi-directional Differential Data Strobe • Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ± 1%) • On Die Termination using ODT pin • Average Refresh Period 7.8us at lower than TCASE 85°C, 3.9us at 85°C < TCASE < 95°C • Asynchronous Reset • PCB : Height 1.180” (30.00mm), single sided component