LAMKIN SINK FIT PISTOL MIDSIZE PUTTER GRIP
Description
The Lamkin Sink Fit Putter Grip has a unique ergonomic design that fits comfortably in the hands of golfers for improved putting control and consistency. Straight profile on the back of the grip with a distinctive ergonomic curve. It has a contoured design that encourages appropriate wrist alignment, resulting in a more controlled and consistent putting stroke. The appropriate putting option for all sorts of golfers is available in various forms in both polyurethane and conventional rubber. GRIP FEATURES: Proprietary Fingerprint Technology featuring a consistent micro-texture pattern for outstanding grip comfort with lighter surface traction Made with Genesis Material that is slightly softer than traditional rubber, but with superior durability Traditional pistol shape that encourages proper hand positioning, wrist alignment Assists in the release of the putter head at impact for a more controlled, consistent putting stroke FREE GRIP TAPE FEATURES Premium ultra thin grip tape Golf specific tape with less residue Width 18mm x Length 50 Metres STEP-BY-STEP REGRIPPING INSTRUCTIONS The following supplies are needed: 1.PRO-GRIP DOUBLE SIDED GRIP TAPE 2.STANLEY KNIFE / BLADE 3.NEW GOLF GRIP 4.SOLVENT WHITE SPIRITS 5.RUBBER GLOVES TO PROTECT HANDS 6. TOWEL / CLOTH STEP 1 - Remove the old grip with a Stanley blade Be sure to cut away from yourself at all times. Peel or scrape off the old grip and grip tape. Using a cloth and Mineral Spirits Grip Solvent, clean off the residue. *If removing a grip from a graphite shaft be careful to avoid damage to the shaft STEP 2 - Wrap your PRO-GRIP double sided grip tape in a spiral formation from the top of the shaft to the point where the bottom of the grip will be on the shaft. Remove the tape backing and cover the end of the shaft with extra tape. STEP 3 - Cover the vent hole in the butt end with your finger or golf tee, and pour a generous portion of Solvent such as white spirits inside the new grip. Close the open end of the grip with your hand and shake to cover the entire inside of the grip. STEP 4 - Pour the excess Mineral Spirits Grip Solvent (through the vent hole) over the entire length of the two-sided tape. Apply generously. Use a tray to catch excess Mineral Spirits Grip Solvent for use on other clubs. STEP 5 - Place the grip over the shaft butt and Push the grip entirely onto the club. Be sure to push it all the way down and align the grip as desired. This must be done while the grip tape is still wet. STEP 6 - Allow grips to dry for several hours before playing.
You may also like
loading